Effective Methods to Test Relays: A Comprehensive Guide for Accurate Results

News

Test a relay with a multimeter by checking coil resistance (usually 50 to 120 ohms), then apply power to the coil and check that the contacts close.

Coil resistance test

  • Remove the relay and note the pin numbers on the label.
  • Set a multimeter to ohms and measure across the coil pins (85 and 86). A typical automotive relay reads 50 to 120 ohms.
  • Infinite resistance means an open coil, bad.

Contact test

  • Measure continuity across pins 30 and 87. It should be open with no power.
  • Apply 12 V to pins 85 and 86 (ground one, power the other). Listen for a click and check continuity again: it should be closed.
How do you test relays: main illustration

Tips

Test under load for accuracy. Replace with the same type.

How do you test relays: visual explanation
How do you test relays: example and key details

Safety

Disconnect the battery.

Based on data from automotive repair manuals and relay manufacturers such as Bosch.

Rate article